Vehicle Dolly (Model B )
This product is suitable for vehicle repair workshop and used for moving the repaired vehicles to replace the front wheel of the car in the workshop. It is required to keep the ground smooth and strong when using this product.
Product Structure and Function:
This product is mainly composed of 2pcs tire selector support a, b. 2pcs 40 × 40 telescopic tube of Support b inserted into the bracket 2 main support bar in a and could be telescopic movement,(as shown in Figure 1) could be adjusted 2pcs tire support in order to meet the needs of different distance between vehicles, tighten the fastening screw fixation of C.
The maximum load capacity:2Ton;
The maximum extensional dimension is 1.65m.
Method of use:
1. Using floor jack or auto lift to hold the car up about 50cm height.
2 .Place this product in lower position of vehicle tyre.
3.Loosen the fastening screws C, adjust the 2 tire selector support distance, keep the bar is under the tire. Tighten the fastening screws. Recommend tire inner gas emissions that will reduce the pressure of about 1/3 to make the vehicles use more secure. After moving the vehicle to the designated position in the workshop and then use the brake block of swivel caster on the support bar stop swivel caster in order to avoid the vehicle glide.
Diagram of Product Assembly:
Tire Selector Support a
Tire Selector Support b
M10 * 25 Bolts
Main Supporting Bar
The Closure Cap
40 x 40 Telescopic Bar
5 Inch Caster
D10 Round Gasket